GRi-975Li / GRx-970Li / GRx-965Li Tracking AdjustmentsUpdated 2 years ago
If you have issues with your trolley not going straight you may have to adjust the tracking. Keep in mind that the cart will drift slightly depending on if you have steep side slopes, rough terrain, etc. On a perfectly flat fairway, a normal tolerance of drift is 1 foot over a 50-foot run.
1. VERIFY both wheels are fully engaged in the drive collar.
2. VERIFY the front fork is tightly secured. Sometimes the 6mm hex bolt will come loose, causing the fork to make erratic movements. If your bolt comes loose more than once, apply some thread locker to the bolt.
If the cart is tracking to the right (from behind the cart):
1. Loosen the 17mm locking cap nut on the Fork side.
2. Loosen the rear #2 Allen set screw 1/4 of a turn (90 degrees).
3. Push the axle tight against the rear set screw.
4. Tighten 17mm cap nut.
5. Test alignment. Readjust if necessary.
6. When satisfactory alignment is achieved, tighten the front set screw down to the axle. Ensure both set screws are snug against the axle.
If the cart is tracking to the left (from behind the cart):
1. Loosen the 17mm locking cap nut on the Fork side.
2. Loosen the front #2 Allen set screw 1/4 of a turn (90 degrees).
3. Pull the axle tight against the front set screw.
4. Tighten the 17mm cap nut.
5. Test alignment. Readjust if necessary.
6. When satisfactory alignment is achieved, tighten the rear set screw down to the axle. Ensure both set screws are snug against the axle.